No tools required
Can be used on any standard valve stem
Adjust tire pressure from 6 to 30psi. in 3psi increments
Easily disassembled to clean out sand or dirt
Simply thread onto stems and walk away
Manual start/stop valve built in
Made from 100% brass material to eliminate rust
Air immediately releases from tire once screwed on
Step 1: Deflate a spare/extra tire to your preferred deflation pressure
Step 2: With the lock ring and adjusting cap wound down, screw your deflator on the valve stem.(Be sure to make sure the threads are clean and in good condition)
Step 3: Loosen cap (counter-clockwise) until deflator pops open, then immediately tighten cap to the
position where the air stops exhausting
Step 4: Turn lock ring up to adjust cap and tighten
Step 5: Installation is now complete and set to your preferred deflation pressure
NOTE: When the tire pressure and the deflator setting within 8psi, a manual start may be required by
fitting the deflator then lifting the center pin to start operation
Pressure Range: 6-30 PSI
Overall Size: 12x39mm/0.47x1.54"
Interface Diameter: 8mm/0.31"
Quantity: 1 Pc
Please allow 1-3mm error due to manual measurement. pls make sure you do not mind before you bid
Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
No Retail Package
1 x Tire Deflator